Since updating the firmware on my light 2 days ago my light will not appear on the Bluetooth set up. I have tried allowing locations, switching phones everything. I am convinced the commander is not working properly. Can you please give me a quick solution as my plants need the light…. This is the only screen I get below. The green light on the power bar is solid and not flashing. Not sure what the next steps are here.
Firmware update fail
- Thread starter Colbz19
- Start date
Update when we removed the commander the light turns on but you cannot control it. Is the commander damaged? Let me know what to do next
- Jun 7, 2023
- 2,124
- 1
- 244
- 63
B 120, firmware never finished. Then afterwards the light will not work. After trouble shooting with no commander it does work. It is a commander 1
Could you please assist with a firmware recovery or send a replacement controller? I believe the update caused the failure.
Thank you very much for your help
- Jun 7, 2023
- 2,124
- 1
- 244
- 63
During firmware update, canot do anything in the app, otherwise it could fail.
Provide an email, we'll send your firmware to manually update.
Similar threads
