Dear support
I really like the feature to customize the light schema as it is the reason I bought this product (Chihiros Universal WRGB 1500).
Am I correct I just need to configure a schema and it will run automatically?
I just configured the customize mode, but I received the notification:
"The number of color control point exceeds the limit, and the device may not behave as expected."
It looks like the program doesn't move now (it is likely 'stuck' after the last supported color control point?).
I need a lot of control points since I need to incorpororate the slopes for each period.
I want to configure 8 periods (dark, moonlight, dawn, morning, daytime, evening, sunset, moonlight, dark).
Could you enhance the firmware so I can just set a fixed slope for each period?
This way I would need only half of the control points:
I would only need to set the desired level for each period, which will be reached after the set slope time.
The pre-set slope time could be a number (of mintues) you need to enter.
The color control points then only need to be set for the desired output level:
Below an example to clarify my desired solution:
pre-set slope time: 5min
color control point 1: time 1, RGBW1
color control point 2: time 2, RGBW2
At time 1, the color levels will start to change to reach RGBW1 after 5 minutes
RGBW1 level will remain till time 2
At time 2, the color levels will start to change to reach RGBW2 after 5 minutes
If this would be to hard to implement, alternatively, I would be happy to have the option the RGBW levels changes instantly at each color control point.
(i.e. the color levels remain fixed as long as the next control point is not reached)
This would be similar as having a pre-set slope of 0 minutes.
Now the RGBW levels continuously change between two color control points,
which is not what I want and is the reason I need to set extra control points to limit the slopes.
Kind regards,
Peter
I really like the feature to customize the light schema as it is the reason I bought this product (Chihiros Universal WRGB 1500).
Am I correct I just need to configure a schema and it will run automatically?
I just configured the customize mode, but I received the notification:
"The number of color control point exceeds the limit, and the device may not behave as expected."
It looks like the program doesn't move now (it is likely 'stuck' after the last supported color control point?).
I need a lot of control points since I need to incorpororate the slopes for each period.
I want to configure 8 periods (dark, moonlight, dawn, morning, daytime, evening, sunset, moonlight, dark).
Could you enhance the firmware so I can just set a fixed slope for each period?
This way I would need only half of the control points:
I would only need to set the desired level for each period, which will be reached after the set slope time.
The pre-set slope time could be a number (of mintues) you need to enter.
The color control points then only need to be set for the desired output level:
Below an example to clarify my desired solution:
pre-set slope time: 5min
color control point 1: time 1, RGBW1
color control point 2: time 2, RGBW2
At time 1, the color levels will start to change to reach RGBW1 after 5 minutes
RGBW1 level will remain till time 2
At time 2, the color levels will start to change to reach RGBW2 after 5 minutes
If this would be to hard to implement, alternatively, I would be happy to have the option the RGBW levels changes instantly at each color control point.
(i.e. the color levels remain fixed as long as the next control point is not reached)
This would be similar as having a pre-set slope of 0 minutes.
Now the RGBW levels continuously change between two color control points,
which is not what I want and is the reason I need to set extra control points to limit the slopes.
Kind regards,
Peter