CHIHIROS WRGB 2 red light

[Robo]

ahoj

môj chihiros WRG II 90cm je červený / problém bol vyriešený pri kúpe nového ovládača.

(nový ovládač - stará originálna verzia - prikladám foto)

Ale po 2 mesiacoch sa problém zopakoval, svieti len na červeno.

Môžete mi pomôcť vyriešiť tento problém.

 

[Administrator]

Light model is WRGB II 90?
In the app My Chihiros, switch into Manual mode, press the Off button, could the red light be turned off?
Check the power adapter, is there a tiny green indicator light? Is it stable or flashing?

 

[Robo]

Áno, model svetla je WRGB II 90

Červené svetlo sa nedá vypnúť v My Chihiros v manuálnom režime.

Napájací adaptér má stále zelené svetlo.

Červené svetlo sa dá vypnúť iba vytiahnutím zo zásuvky.

 

[Administrator]

In the app Manual mode, slide each RGB channels separately, Green and Blue work properly, right?
For the red channel, from 0% to the Max, what will the light show?

 

[Administrator]

Take a photo of the SN code on the newly replaced Bluetooth Controller.
When and where did you buy the light?

 

[Robo]

I am sending the application settings:

* when turned on only blue - light blue / red = violet bad / application OK - photo blue

* only green when switched on - network light on green / error in the application - photo gren

* when it is red, only red - lit / error in the application - photo red



When turned off, the light turns red.

 

[Robo]

I have had the light for about 3 years (2021) - it worked for 3 years without any problems. When there was a problem with the red light, I bought a new Bluetooth Controller.

But after two months, the problem recurred - the light is red again.


There is no SN label on the Bluetooth Controller - I am attaching a photo of the stickers.

 

[Administrator]

I am sending the application settings:

* when turned on only blue - light blue / red = violet bad / application OK - photo blue

* only green when switched on - network light on green / error in the application - photo gren

* when it is red, only red - lit / error in the application - photo red



When turned off, the light turns red.

You need to test each color in Manual mode not customize mode.
1. Test Red channel: Green and Blue at 0%, slide Red from 0% to the max, how would the light react?
2. Test Green channel: Red and Blue at 0%, slide Green from 0% to the max, how would the light react?
3. Test Blue channel: Red and Green at 0%, slide Blue from 0% to the max, how would the light react?

 

[Administrator]

4. Test All button: Press the All button, how would the light react?
5. Test Off button: Press the Off button, how would the light react?

You can take screenshots of all those 5 settings in the app, and show us photo or video of how the light reacts in those 5 different situation. Screen video is more convenient for technicians to check.
Also you can take a screenshot of the Device Information page which includes device ID NO and Firmware Version.

 

[Robo]

I am sending the application settings - the same behavior:

* when turned on only blue - light blue / red = violet bad / - photo blue

* only green when switched on - network light on green / - photo gren

* when it is red, only red - lit / - photo red

at 0% it glows dimly red. At 1%, red turns off and the selected color starts to glow. Add more to intensify your chosen color.

 

[Robo]

I am sending additional settings:

* ALL – all are lit

* OFF - lights up red

+ ID NO and Firmware Version